User Manual

TRACER 4206 System Manual Section 5, User Interface Guide
612804206L1-1A © 2002 ADTRAN, Inc. 43
3. MENU DESCRIPTIONS
The remainder of this section describes the TRACER 4206 menus and submenus.
>TRACER SYSTEM STATUS
Figure 2 shows the TRACER System Status menu page. Status of major system components for both sides
of the TRACER link are displayed, but no configuration can be performed from this view.
Figure 2. TRACER System Status
The top of the TRACER System Status menu page displays the elapsed time the TRACER 4206 system
has been operational since the last power reset. Located directly beneath the ADTRAN Technical Support
phone number is a graphical indicator of the status of the TRACER 4206 T1 and RF links (as reported by
both the local and remote units). The T1 labels will be reverse highlighted if any error conditions exist on
that T1 interface.
The status of the received radio link is indicated as RF UP or RF DOWN for each direction. The left portion
of the menu page reports the status of the local TRACER 4206 (the system where the active terminal is
attached). The right portion of the screen reports the status of the remote system. If the RF link is down,
DATA NOT AVAILABLE will be displayed in place of the remote system status.
To enter the TRACER main menu, press <M>.
The menu structure of the TRACER 4206 system is depicted below as follows:
>
MENU PAGE
> MENU PAGE > MENU SELECTION
> MENU PAGE > MENU SELECTION > SUB-MENU