User Manual
Table Of Contents
- System Description
- Microwave Path Engineering Basics
- Engineering Guidelines
- Network Turnup Procedure
- User Interface Guide
- 1. Navigating the Terminal Menu
- 2. Terminal Menu and System Control
- 3. Menu Descriptions
- >TRACER System Status
- >Main Menu
- >TRACER System Configuration
- >TRACER Link Performance History
- >T1A Status/Configuration/Loopback
- >T1A Performance History
- >T1B Status/Configuration/Loopback
- >T1B Performance History
- >T1C Status/Configuration/Loopback
- >T1C Performance History
- >T1D Status/Configuration/Loopback
- >T1D Performance History
- Troubleshooting Guide
TRACER 4206 System Manual Section 5, User Interface Guide
612804206L1-1A © 2002 ADTRAN, Inc. 41
1. NAVIGATING THE TERMINAL MENU
The TRACER 4206 menu system can be accessed with a VT100 compatible terminal set to 9600 bits per
second, 8 data bits, 1 stop bit, and no parity, connected to the RS-232 port located on the back of the unit.
Flow control on the serial interface should be configured to None for proper operation. Once a terminal is
connected, pressing <Ctrl + L> will refresh the current screen. If password access has been enabled, the
ENTER PASSWORD message will be displayed at the bottom of the TRACER 4206 system status menu.
Terminal Menu Window
The TRACER 4206 uses 11 (eleven) menu pages and a single main menu page to access its many features.
The main menu page (see Figure 1) provides a link to all available configuration/status pages.
Figure 1. Main Menu Screen
All TRACER 4206 systems are shipped factory default with password protection disabled.
After connecting a VT100 terminal to the TRACER 4206, press <Ctrl + L> to redraw the
current screen.