User Manual
Table Of Contents
- System Description
- Microwave Path Engineering Basics
- Engineering Guidelines
- Network Turnup Procedure
- User Interface Guide
- 1. Navigating the Terminal Menu
- 2. Terminal Menu and System Control
- 3. Menu Descriptions
- >TRACER System Status
- >Main Menu
- >TRACER System Configuration
- >TRACER Link Performance History
- >T1A Status/Configuration/Loopback
- >T1A Performance History
- >T1B Status/Configuration/Loopback
- >T1B Performance History
- >T1C Status/Configuration/Loopback
- >T1C Performance History
- >T1D Status/Configuration/Loopback
- >T1D Performance History
- Troubleshooting Guide
TRACER 4206 System Manual Section 4, Network Turnup Procedure
612804206L1-1A © 2002 ADTRAN, Inc. 37
7. MOUNTING OPTIONS
Install the TRACER 4206 in a location that requires minimal antenna feedline length (the loss in this cable
directly affects overall system performance). The TRACER 4206 is designed to be mounted in a rack. If
multiple units are installed in one location, one half inch of spacing is recommended above and below the
unit.
8. CONNECTING THE T1 INTERFACE
The physical T1 interface is provided using 4 RJ-48C jacks for transmit and receive. The provided straight
through T1 interface cables can be used to interface to any standard T1 DTE device.