User Manual
Table Of Contents
- Trademarks
- About this Manual
- Federal Communications Commission Radio Frequency Interference Statement
- Warranty and Customer Service
- Customer Service, Product Support Information, and Training
- 4205 System Description
- Microwave Path Engineering Basics
- Engineering Guidelines
- Network Turnup Procedure
- User Interface Guide
- Troubleshooting Guide
TRACER 4205 System Manual Section 5, User Interface Guide
612804205L1-1A © 2002 ADTRAN, Inc. 43
>TRACER SYSTEM CONFIGURATION
Figure 4 shows the TRACER System Configuration menu page. System configuration parameters for both
the local and remote TRACER 4205 units are available through this menu page.
Figure 4. TRACER System Configuration
>TRACER SYSTEM CONFIGURATION > RX POWER
Displays the approximate receiver levels (for both the local and remote units) using a series of symbols (#).
The more symbols (
#) displayed, the stronger the signal. If the link is down and remote end data is
unavailable, DATA NOT AVAILABLE is displayed in place of the symbols (#). This parameter is display only.
>TRACER SYSTEM CONFIGURATION > TX POWER
Allows the transmitter levels (for both the local and remote units) to be adjusted. The current transmitter
level is displayed using a series of symbols (#). The more symbols (#) displayed, the stronger the signal. If
the link is down and remote end data is unavailable, DATA NOT AVAILABLE is displayed in place of the
symbols (#).
Press <1> from any menu in the TRACER 4205 VT100 menu structure to access the
TRACER System Configuration menu page.
Reducing the transmitter power of the remote TRACER 4205 could negatively impact the
TRACER RF link.