User's Manual

Table Of Contents

Section 5 User Interface Guide TRACER 4108/4208 System Manual

1. NAVIGATING THE TERMINAL MENU

The TRACER 4108/4208 menu system can be accessed with a VT100 compatible terminal that is

connected to the RS-232 port located on the back of the unit and set to 9600 bits per second, 8 data bits, 1

stop bit, and no parity. Flow control on the serial interface should be configured to

NONE for proper

operation. Once a terminal is connected, press <Ctrl + L> to refresh the current screen. If password access

has been enabled, the

ENTER PASSWORD message displays at the bottom of the TRACER 4108/4208

System Status menu.

Terminal Menu Window

The TRACER 4108/4208 uses a series of menu pages and a single main menu page to access its many

features. The main menu page (see Figure 1) provides a link to all available configuration/status pages.

Figure 1. Main Menu Screen

All TRACER 4108/4208 systems are shipped factory default with password protection

disabled.

After connecting a VT100 terminal to the TRACER 4108/4208, press <Ctrl + L> to redraw

the current screen.