User guide

Configuring and Starting an Ethernet Test or Tool
44 AXS-200/805/855
Configuring a Trace Route Tool
Configuring a Trace Route Tool
To configure the Trace Route tool:
1. Configure the interface by configuring the port, network, and VLAN
settings. Refer to Interface on page 45. Ensure that the link is up before
proceeding to the next step.
2. Press , select ETHERNET, Tools, Trace Route, and the Trace Route
Configuration tab.
3. Configure the Trace Route tool by referring to Trace Route
Configuration on page 198.
4. Press to start or stop the tool.
Configuring Cable Test Tool
To configure the Cable Test tool:
1. Configure the interface port Transceiver Mode to Electrical and the
speed to either 10Mbps/100Mbps for two-pair cable test or 1Gbps for
four-pair cable test. Refer to Port on page 46.
2. Press , select ETHERNET, Tools, Cable Test, and the Configuration
tab.
3. Configure the Cable Test tool by referring to Cable Test Configuration
on page 202.
4. Press to start the cable test tool.