User guide

Configuring and Starting an Ethernet Test or Tool
Multi Protocol Test Set 43
Configuring a Smart Loopback Test
Configuring a Smart Loopback Test
To configure the Smart Loopback test:
1. Configure the interface by configuring the port, network, and VLAN
settings. Refer to Interface on page 45. Ensure that the link is up before
proceeding to the next step.
2. Press , ETHERNET, and select Smart Loopback.
3. The test can be started from this page and the statistics are displayed
on the same page.
4. Press to start or stop the test.
Configuring a Ping Tool
To configure the Ping tool:
1. Configure the interface by configuring the port, network, and VLAN
settings. Refer to Interface on page 45. Ensure that the link is up before
proceeding to the next step.
2. Press , select ETHERNET, Tools, Ping, and the Ping Configuration
tab.
3. Configure the Ping tool by referring to Ping Configuration on page 192.
4. Press to start or stop the tool.