User guide

Configuring and Starting an Ethernet Test or Tool
40 AXS-200/805/855
Configuring a BERT Test
Configuring a BERT Test
To configure the BERT test:
1. Configure the interface by configuring the port, network, and VLAN
settings. Refer to Interface on page 45. Ensure that the link is up
(indicated by the platform LED) before proceeding to the next step.
2. Optionally, set a remote module in loopback. Refer to Remote
Selection on page 58.
3. Press , select ETHERNET, BERT, Configuration, and the Global tab.
4. Configure the global settings by referring to Global Configuration on
page 109.
5. Select the Stream tab.
6. Configure the stream by referring to Stream Configuration on page 113.
7. Press to start or stop the test.