User guide

Ethernet Tools
Multi Protocol Test Set 203
Cable Test Configuration
Wiring Standard: Select the pin-to-pair
assignment corresponding to the UTP
cable used. Choices are T568A and
T568B. The default setting is T568A.
³ Length Unit: Select the unit that will be used for cable length and
distance to fault results. Choices are Meter and Feet. The default
setting is Meter.
³ Pass/Fail Verdict: Enable Pass/Fail Verdict to display the Pass/Fail
verdict on the cable test result pages. The default setting is enabled.
Note: The following parameters are only available when the Pass/Fail Verdict is
enabled.