User guide

Ethernet Traffic Generation & Monitoring Test
Multi Protocol Test Set 155
Network Configuration
Network Configuration
Network Configuration allows to configure the network parameters for the
background streams.
Press , select ETHERNET, Traffic Generation & Monitoring,
Background Stream Config, and the Network tab.
When IPv4 version is selected, configure the following fields in the Stream
tab.
³ Background Stream: Select any
of the three background streams
for which the network parameters
are to be configured.
³ IP Address: Configure the source
IP Address for the selected
background stream. The default
IP address is 10.10.0.0.
³ Subnet Mask: Configure the
Subnet Mask for the selected background stream. The accepted range
is from 0.0.0.0 to 255.255.255.255. The default value is 255.255.0.0.
³ Default Gateway: Enable or disable the Default Gateway. The default
setting is Enabled. If enabled, enter the default gateway address for
the Ethernet port. The default value is 0.0.0.0.