User guide

Ethernet Traffic Generation & Monitoring Test
Multi Protocol Test Set 147
Jitter/Latency Configuration
Latency Configuration
³ Latency: The Latency parameter allows to enable or disable the
Latency proprietary information insertion in the payload.
Note: If Disabled is selected, the Latency meter is disabled. See Latency on
page 165.
³ Latency Pass/Fail Verdict: Enable Latency Pass/Fail Verdict to display
Latency Pass/Fail Verdict on the Jitter/Latency results page.
Threshold: When the Latency Pass/Fail Verdict is enabled, Threshold
value can be set in milliseconds. Latency Pass/Fail Verdict is declared
as PASS when the maximum latency value is smaller than or equal to
the threshold. Latency Pass/Fail Verdict is declared as FAIL when the
maximum latency value is greater than the threshold.