User guide

Ethernet Traffic Generation & Monitoring Test
Multi Protocol Test Set 133
Global Configuration
Global Configuration
The Global page allows configuring the main stream properties and global
test parameters such as duration and rate unit.
Press , select ETHERNET, Traffic Generation & Monitoring, Stream
Config, and the Global tab.
³ Rate Unit: Select the unit for the transmission and receive rate.
Choices are Mbps and %. The default setting is Mbps.
³ Duration: Set the duration of the
test. The choices are as follows:.
³ 15-Min
³ 1-Hour
³ 2-Hours
³ 4-Hours
³ 6-Hours
³ 12-Hours
³ 24-Hours
³ User Defined
³ Disabled: Runs the test for infinite time. It can be stopped
manually at any point of time.
The default value is Disabled. Select the duration field next to User
Defined and a pop up menu will be displayed to configure the test
duration.
³ TX: Enable or disable main stream transmission. The default value is
Enabled.
³ Framing: Select the frame structure of the main stream. Choices are
Ethernet/IPv4/UDP or Ethernet/IPv6/UDP and Ethernet. The default
setting is Ethernet.