User guide

Introducing the AXS-200/805/855 Multi Protocol Test Set
2 AXS-200/805/855
DS1/DS3 Key Features
DS1/DS3 Key Features
E1 Key Features
ISDN Key Features
Dual independent DS1 tests
Alarm/error insertion and detection
Performance monitoring
Performance testing at any fractional T1 rate; both contiguous
and non-contiguous n x 64 kbit/s are supported
VF analysis measures different tone levels
Round-trip delay (RTD) measurements
Support for automatic pattern detection and 12 different
stress patterns
DS1 inband and FDL loopbacks
HDSL PairGain and Adtran loopbacks
Smart and intelligent repeater loopback sequences
RBS monitoring
CSU/NIU emulation
Terminate, Monitor and Through mode
Excessive zeros Tx and Rx
DS1 drop
FEAC control
Dual independent E1 tests
Alarm/error insertion and detection
Performance monitoring
Performance testing at any fractional E1 rate; both contiguous
and non-contiguous n x 64 kbit/s are supported
VF analysis measures different tone levels
Round-trip delay (RTD) measurements
Support for automatic pattern detection and 12 stress patterns
CAS monitoring
Simultaneous signaling state status of all 30 channels
Terminate and Monitor mode
Excessive zeros Tx and Rx
Make a call in either voice, raw data or 3.1 kHz audio
Terminate one or all calls
Auto routing of data calls to BERT test
Talk set support allows users to use a butt set to talk
on an active call
Caller identification gives the call type, selected B channel,
dialed number and caller’s number
Q.931 decoding shows how calls are established,
maintained and terminated across the ISDN network
Call/answer and hold all 23 or 30 channels for seamless
testing
NT (CO) and TE (PBX) emulation to isolate the network
or CPE side