User guide

payload—For channelized T3, T1, and NxDS0 IQ interfaces only, loop back data only
(without clocking information) on the remote router’s PIC. With payload loopback,
overhead is recalculated. Neither ATM-over-asymmetrical digital subscriber line
(ADSL) interfaces nor ATM-over-SHDSL interfaces support payload loopback.
remote—Loop packets, including both data and timing information, back on the remote
router’s interface card. NxDS0 IQ interfaces do not support remote loopback.
Required Privilege
Level
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Related
Documentation
• Configuring E3 and T3 Parameters on ATM Interfaces
• Configuring E1 Loopback Capability on page 10
• Configuring E3 Loopback Capability
• Configuring SONET/SDH Loopback Capability
• Configuring SHDSL Operating Mode on an ATM Physical Interface
• Configuring T1 Loopback Capability
• Configuring T3 Loopback Capability
• feac-loop-respond
Copyright © 2014, Juniper Networks, Inc.50
E1 Interfaces Feature Guide for Routing Devices