User manual

Total Access 600 Series T1 ATM IAD UIG/64200681L2-31B
Page 27
© 2002, ADTRAN, Inc. Total Access 600 Series User Manual
Configuring WAN Settings
>DSLAM Type
Set this to the type of DSLAM the Total Access 600 will be connecting to.
>Layer One Interface
This is the physical layer protocol used to connect the DSLAM to the Total Access 600.
>Layer Two Protocol
This is the data link layer protocol used to connect the DSLAM to the Total Access 600.
>ATM Config
Use the :
$1
menu (Figure 6) to access the $70&
21),*
menu.
Figure 6. WAN Menu
Use the $70&
21),*
menu (Figure 7) to set the parameters listed below the figure.
If the DSLAM Type is CopperMountain, refer to Appendix H. Routing in HDIA Mode on page 71 for
information.