Modem Installation And Maintenance Practice
Table Of Contents
- Total Access 1240 Installation and Maintenance Practice
- Front Matter
- Section 1, Introduction
- Section 2, Application Guidelines
- Section 3, Installation
- Section 4, Provisioning Defaults
- Section 5, User Interface
- Introduction
- System Management
- Logging on to the Total Access 1240
- Menu Structure
- Menu Navigation
- Menu Trees
- Menu Descriptions
- Configuration Screen
- Bridge Circuit Management Menu
- System Management Menu
- SHDSL Ports Menu
- System Alarm Log Screen
- Contact Information Screen
- Section 6, Maintenance
- Section 7, Specifications
- Appendix A, Declaration of Conformity
- Appendix B, SCA File Format
- Appendix C, Warranty
Section 5, User Interface - Menu Descriptions
61179605L5-5B 5-41
Table 5-31. Static IP Settings - for IP over Ethernet Menu Options
Option Description Function
1 IP address This options is used to configure the IP address in
decimal dot format (i.e., ###.###.###.###).
2 Subnet mask This option is used to configure the Subnet Mask in
decimal dot format.
3 Default Gateway This option is used to configure the Default Gateway.
The Default Gateway is used to forward traffic to a
destination outside of the subnet of the Total Access
1240. The Default Gateway is configured in decimal dot
format.
4 TFTP IP address This option is used to configure the TFTP IP address.
The TFTP IP address must be configured to use TFTP for
software upgrade. The TFTP address is configured in
decimal dot format.
5 Reset IP Factory Defaults This option displays the “Restore IP Factory Defaults
Menu” on page 5-42.
6 IP VLAN ID This option is used to set the IP VLAN ID.
The IP VLAN ID must be set between 1 and 4094.
Choosing 1 indicates an untagged VLAN ID. Choosing
between 2 and 4094 indicates a tagged VLAN ID.