Modem Installation And Maintenance Practice
Table Of Contents
- Total Access 1240 Installation and Maintenance Practice
- Front Matter
- Section 1, Introduction
- Section 2, Application Guidelines
- Section 3, Installation
- Section 4, Provisioning Defaults
- Section 5, User Interface
- Introduction
- System Management
- Logging on to the Total Access 1240
- Menu Structure
- Menu Navigation
- Menu Trees
- Menu Descriptions
- Configuration Screen
- Bridge Circuit Management Menu
- System Management Menu
- SHDSL Ports Menu
- System Alarm Log Screen
- Contact Information Screen
- Section 6, Maintenance
- Section 7, Specifications
- Appendix A, Declaration of Conformity
- Appendix B, SCA File Format
- Appendix C, Warranty
Total Access 1240 Installation and Maintenance Practice
5-40 61179605L5-5B
Static IP Settings - for IP over Ethernet Menu
The Static IP Settings - for IP over Ethernet menu (see Figure 5-27) is used to manually
provision all of the IP settings.
Figure 5-27. Static IP Settings - for IP Over Ethernet Menu
NOTE
The Media Access Control (MAC) address, which is set at the
factory, is required to configure the DHCP server.
The Static IP Settings - for IP over Ethernet menu options are shown in Table 5-31.
3 Configure IP Depending on the setting of the Mode option, the
Configure IP option displays one of the following menus:
• “Static IP Settings - for IP over Ethernet Menu” on
page 5-40
• “Dynamic IP Settings - for IP over Ethernet Menu”
on page 5-43
Table 5-30. Mode Selection and Current IP Settings Menu Options (Continued)
Option Description Function
Total Access 1240 - IPoE Fed
Unacknowledged Alarms: None
Static IP Settings - for IP over Ethernet
1. IP address 192.168.1.1
2. Subnet mask 255.255.255.0
3. Default Gateway 192.168.1.254
4. TFTP IP address 10.200.200.218
5. Reset IP Factory Defaults
6. IP VLAN ID 1
(Vlan = 1 is untagged / 2-4094 is tagged)
MAC Address 00-a0-c8-12-4c-7c
Selection :
'?' - System Help Screen