Modem Installation And Maintenance Practice
Table Of Contents
- Total Access 1240 Installation and Maintenance Practice
- Front Matter
- Section 1, Introduction
- Section 2, Application Guidelines
- Section 3, Installation
- Section 4, Provisioning Defaults
- Section 5, User Interface
- Introduction
- System Management
- Logging on to the Total Access 1240
- Menu Structure
- Menu Navigation
- Menu Trees
- Menu Descriptions
- Configuration Screen
- Bridge Circuit Management Menu
- System Management Menu
- SHDSL Ports Menu
- System Alarm Log Screen
- Contact Information Screen
- Section 6, Maintenance
- Section 7, Specifications
- Appendix A, Declaration of Conformity
- Appendix B, SCA File Format
- Appendix C, Warranty
Section 5, User Interface - Menu Descriptions
61179605L5-5B 5-23
Ethernet Provisioning Menu
The Ethernet Provisioning menu (see Figure 5-16) is used to configure the Ethernet port. The
Ethernet port is used to connect the Total Access 1240 to a network.
Figure 5-16. Ethernet Provisioning Menu
The Ethernet Provisioning menu options are shown in Table 5-13.
Table 5-13. Ethernet Provisioning Menu Options
Option Description Function
1 Duplex Mode This option displays the “Duplex Mode Menu” on page
5-24.
2 Speed This option displays the “Speed Mode Menu” on page
5-25.
Total Access 1240 - IPoE Fed 09/01/05 03:44
Unacknowledged Alarms: None
Ethernet Provisioning
1. Duplex Mode Full Duplex
2. Speed 100Base
Selection :
Ethernet Link: Not Active
'?' - System Help Screen