User manual
Appendix A. Dial Plan Interface Configuration
A-10 Dual T1/PRI Module User Manual 61200314L1-1
S
OURCE
ID
Write security: 3; Read security: 5
Simplifiesthecreationofa D
IAL
P
LAN
inapplications wherethecriterion for
switching calls to a certain endpoint is a function of which endpoint origi-
nated the call.
• Default value = 0. The default ID for all endpoints is 0 and all accept
numbers is 0. With default values, all calls are routed based only on the
dialed number.
• Multiple endpoints can have the same S
OURCE
ID.
• When creatingtheC
ALL
A
CCEPT
list, specifya S
OURCE
ID(s)aswellasa
dialed number or range of dialed numbers to accept.
E
XAMPLE
:
An application requires that all calls that originate from Port 1 of the Dual
T1/PRI Module in Slot 1 be switched to Port 2 of that same module. Assign
a unique Source ID (e.g. 7) to Port 1 ofthe module, andthen configure Port
2 to only accept calls from that unique Source ID (7).
S
WAP
ANI/DNIS
Write security: 3; Read security: 5
Swaps the ANI and DNIS numbers received from the network. ANI (Auto-
matic Number Identification) is the billing number of the calling party, and
DNIS (Dialed Number Identification Service) is the called party number.
DUAL T1/PRI MODULE: USER TERMINATION/RBS
When you are working in the user termination section of the D
IAL
P
LAN
menu, when S
LT
is defined as T1/PRI-2,andwhenS
IG
is set to RBS, the fol-
lowing configuration options are available:
F
IRST
DS0
Write security: 3; Read security: 5
Defines to the ATLAS 550 the first DS0 for this endpoint. The ATLAS 550
uses DS0s, starting with this selection, to send andreceive calls toand from
the network (PSTN). The outgoing calls which are allowed or restricted
over these DS0s are set by the O
UTGOING
C
ALL
A
CCEPT
and R
EJECT
N
UM
-
BERS
(discussed in the ATLAS 550 User Manual).
N
UMBER OF
DS0
S
Write security: 3; Read security: 5
Specifies the number of DS0sATLAS 550 uses for this endpoint.
With this swap, the ATLAS 550 switchboard uses ANI to route the
call.TheacceptnumberintheDialPlanmustusetheANInumber,
not the DNIS number.