User manual

Appendix A. Dial Plan Interface Configuration
61200314L1-1 Dual T1/PRI Module User Manual A-5
S
WAP
ANI/DNIS
Write security: 3; Read security: 5
Swaps the ANI and DNISnumbers receivedfrom the network. ANI (Auto-
matic Number Identification) is the billing number of the calling party, and
DNIS (Dialed Number Identification Service) is the called party number.
DUAL T1/PRI MODULE: NETWORK TERMINATION/RBS
When you are working in the network termination section of the D
IAL
P
LAN
menu, when S
LT
is defined as T1/PRI-2,andwhenS
IG
is set to RBS, the fol-
lowing interface configuration options are available:
F
IRST
DS0
Write security: 3; Read security: 5
Defines to the ATLAS 550 the first DS0 for this endpoint.The ATLAS 550
uses DS0s, starting with this selection, to sendand receive calls to and from
the network (PSTN). The outgoing calls which are allowed or restricted
over these DS0s are set by the O
UTGOING
C
ALL
A
CCEPT
and R
EJECT
N
UM
-
BERS
(discussed in the ATLAS 550 User Manual).
N
UMBER OF
DS0
S
Write security: 3; Read security: 5
Specifies the number of DS0s the ATLAS 550 uses for this endpoint.
DS0
S
A
VAILABLE
Read security: 5
Indicates whichDS0s of the T1 have been defined in thisswitched endpoint
(indicated by “! “), in another switched endpoint (indicated by “s”), or in a
D
EDICATED
M
AP
(indicated by “n”). This field is read-only. The following
characters may display in this field:
With this swap, the ATLAS 550 switchboard uses ANI to route the
call.TheacceptnumberintheDialPlanmustusetheANInumber,
not the DNIS number.
0-9 This DS0 is available. The digit that displays in this field represents
the last digit of the DS0 number.
* ThisportisrequestingthisDS0for this connection,buttheDS0isnot
yet activated.
! ThisDS0isusedbythisendpoint.
s This DS0 is used elsewhere in the switched D
IAL
P
LAN
.
S ThisDS0 is intheswitcheddialplan andconflicts withthisendpoint.
n This DS0 is used in one or more D
EDICATED
M
APS
.
N This DS0 is in one or more D
EDICATED
M
APS
, and conflicts withthis
endpoint.