Specifications

Frame Relay Sub-Interface Config Command Set Command Reference Guide

FRAME RELAY SUB-INTERFACE CONFIG COMMAND SET

To activate the Frame Relay Interface Configuration command set, enter the interface frame-relay

command (and specify a sub-interface) at the Global Configuration Mode prompt. For example:

Router>

enable

Router#

configure terminal

Router(config)#

interface frame-relay 1

Router(config-fr 1.16)#

The following commands are common to multiple command sets and are covered in a centralized section

of this guide. For more information, refer to the sections listed below:

do on page 558

end on page 559

exit on page 560

All other commands for this command set are described in this section in alphabetical order.

access-policy <policyname> on page 413

bandwidth <value> on page 416

bridge-group <group#> on page 417

bridge-group <group#> path-cost <value> on page 418

bridge-group <group#> priority <value> on page 419

bridge-group <group#> spanning-disabled on page 420

crypto map <mapname> on page 421

dial-backup commands begin on page 423

frame-relay bc <committed burst value> on page 440

frame-relay be <committed burst value> on page 441

frame-relay interface-dlci <dlci> on page 442

ip commands begin on page 443

mtu <size> on page 459