Specifications

Crypto Map IKE Command Set Command Reference Guide

CRYPTO MAP IKE COMMAND SET

To activate the Crypto Map IKE command set, enter a valid version of the crypto map ipsec-ike

command at the Global Configuration Mode prompt. For example:

Router>

enable

Router#

configure terminal

Router(config)#

crypto map Map-Name 10 ipsec-ike

Router(config-crypto-map)#

The following commands are common to multiple command sets and are covered in a centralized section

of this guide. For more information, refer to the sections listed below:

do on page 558

end on page 559

exit on page 560

All other commands for this command set are described in this section in alphabetical order.

match address <listname> on page 277

set peer <address> on page 279

set pfs [group1 | group2] on page 280

set security-association lifetime [kilobytes | seconds] <value> on page 281

set transform-set <setname1 - setname6> on page 282

For VPN configuration example scripts, refer to the technical support note

Configuring VPN located on the NetVanta 3000 Series System Manual CD provided with

your unit.