Technical data

4-4 NetBlazer and LAN Setup 90362-01
You see the NetBlazer Port Setup screen:
Figure 4-2. The NetBlazer Port Setup Screen
3.
Move to
IP LAN
,
IPX LAN
, or
AppleTalk LAN
and press Enter.
The following section describes how to configure the NetBlazer to
route IP packets to the local network. Configuring the NetBlazer to
route IPX is described on page 4-6; configuring the NetBlazer to
route AppleTalk is described on page 4-8. When you are done con-
figuring the protocols, remember to save your configuration.
Selecting
Line setup
is described in Chapter 5, “Line Setup.” Select-
ing
ISDN setup
is described in Chapter 6, “ISDN Connections.”
Configuring IP Routing
You can use Worksheet 2, the “LAN Setup for IP” worksheet on page B-5
to record and organize the information you need to complete the tasks in this
section.
To configure the NetBlazer to route IP packets, follow these steps:
NetBlazer Port Setup NetBlazer Setup Utility V3.0
To configure the LAN protocols, move to “IP LAN”, “IPX LAN” or
“AppleTalk LAN” and press Enter. Use “Line setup” to configure lines,
“ISDN setup” to set the switch type and SPIDs for ISDN connections.
Previous
IP LAN
IPX LAN
AppleTalk LAN
Line setup
ISDN setup
Help
Return to Main Menu
Press Enter to return to the previous screen