Technical data
90362-01 Using the Setup Utility 3-5
Telnet to NetBlazer’s Default Address
If you are able to add an IP route to a host on the same LAN segment as the
NetBlazer, you can use the following procedure to configure the NetBlazer
through a telnet session:
1.
Choose a TCP/IP host that is on the same LAN segment as the
NetBlazer and add the NetBlazer’s default address (192.0.2.1) to
that host’s routing table. For example, on a Sun system you would
enter a
route add 192.0.2.1
‘
hostname
’
0
command.
2.
Verify that you can communicate with the NetBlazer by issuing a
ping 192.0.2.1
command.
3.
If you received the proper response from the ping, enter a
telnet
192.0.2.1
command to establish a connection with the NetBlazer.
Rest of the
Local Network
NetBlazer LS
TCP/IP Host
LAN Segment
Configure host to route IP
packets to NetBlazer’s default
address 192.0.2.1