Technical data

3-4 Using the Setup Utility 90362-01
Direct Null-modem Connection
To use the NetBlazer Setup Utility by way of a null-modem connection,
perform the following steps:
1.
Connect a null-modem cable assembly between your NetBlazer and
a PC or terminal.
2. If you are using a PC with a terminal emulation program such as
Windows Terminal, start your communications program and make
sure that it is set to 9600 bps, 8 bits, 1 stop bit, no parity, and
XON/XOFF flow control.
3.
Turn on your NetBlazer. If your connection is set up properly, you
will see the NetBlazer’s login prompt after it has loaded its operating
software.
4.
Log in as
setup
to run the NetBlazer Setup Utility. Refer to “Starting
the Setup Utility” on page 3-7 for instructions on using the Setup
Utility.
Null-modem connection
Local
Network
NetBlazer LS