Technical data

90362-01 NetBlazer LS Installation 2-1
NetBlazer LS Installation 2
The NetBlazer LS is currently shipped in two models, the LS ISDN (LS
I-1BS) and the LS 2-PT (LS 2S/A), known as Dual DTE. Illustrations of
these model’s back panels are shown in the following sections.
Both models have one LocalTalk port, and one Ethernet port which can use
either a BNC or UTP connection. Both models are shipped with one Ether-
net and one LocalTalk adapter pre-installed. You can have a maximum of
two LANs connected to your NetBlazer LS (one Ethernet and one
LocalTalk).
Dual DTE Installation
*Or, if your setup will be done remotely, connect the NetBlazer to a modem
so you can dial in to configure it.
Figure 2-1. Dual DTE Back Panel and Install Instructions
3. Plug in the
power cable.
2.
Connect any LAN
cables to the LocalTalk or
Ethernet ports.
1.
Connect a null modem cable
from your computer to the
NetBlazer.*
Ethernet
SN
Sync/Async DTE Line 00 Sync/Async DTE Line 01
PowerBNC UTPLocalTalk
4.
Turn on the power switch.
MAC Addr