Technical data

90362-01 NetBlazer LS Configuration Worksheets B-13
Worksheet 10. Dial-up AppleTalk Protocol
To configure a dial-up connection so your local NetBlazer can route AppleTalk:
1. Set NetBlazer name and password (Worksheet 1) and configure NetBlazer
LAN protocols (Worksheet 2, Worksheet 3, or Worksheet 4).
2. Set up the Interface as shown in the Dial-up LAN-to-LAN Interface
Worksheet (Worksheet 7).
3. On the Dial-up Connection screen, select “Protocol details”.
4. Select “Enable AppleTalk”.
5. Once you know that the other end of the connection has been configured,
select “Learn AppleTalk routes”.
When you select “Learn AppleTalk routes” the NetBlazer dials the NetBlazer at
the other end of the link to learn its routing information. Allow up to three minutes
for this to be completed. You cannot proceed until this operation is complete.
Your
Local
Network
The
Remote
Network
Telephone
Network
NetBla