Technical data

B-12 NetBlazer LS Configuration Worksheets 90362-01
Worksheet 9. Dial-up IPX Protocol
To configure a dial-up connection so your NetBlazer can route IPX:
1. Set NetBlazer name and password (Worksheet 1) and configure NetBlazer
LAN protocols (Worksheet 2, Worksheet 3, or Worksheet 4).
2. Set up the Interface as shown in the Dial-up LAN-to-LAN Interface
Worksheet (Worksheet 7).
3. On the Dial-up Connection screen, select “Protocol details”.
4. Select “Enable IPX”.
5. Once you know that the other end of the connection has been configured,
select “Learn IPX routes”.
When you select “Learn IPX routes” the NetBlazer dials the NetBlazer at the other
end of the link to learn its routing information. Allow up to three minutes for this to
be completed. You cannot proceed until this operation is complete.
Your
Local
Network
The
Remote
Network
Telephone
Network
NetBla