Technical data

B-6 NetBlazer LS Configuration Worksheets 90362-01

Worksheet 3. LAN Setup for IPX

To configure your NetBlazer to route IPX on the LAN:

1. Set your NetBlazer name and password (Worksheet 1).

2. Select “NetBlazer port setup” from the Main Menu screen.

3. Select “IPX LAN” from the NetBlazer Port Setup screen and work through the fields

below that apply to your network.

Global address

The Global address must be different from every other network device.

interface

address en0

_________________________________

Interfaces with names beginning with

are for Ethernet.

NOTE: If an address already exists in an interface address field,

do not

change it. The

NetBlazer may automatically learn the current IPX address. If you need to enter an address in

this field, it should match the Global address.

If you’ll also be routing IP or AppleTalk, use Worksheet 2 and Worksheet 4 as you continue

with the configuration. Or, you may want to save your configuration at this point; return to

the Main Menu and select “Save/Exit” to save.