Setup guide

NetVanta 7100 Administrator’s Guide Configuring the System

Setting Up Status Groups

Status groups are used to allow ADTRAN/Polycom IP phones to monitor the current status of other users,

park zones, system modes, or mailboxes. Configuring status groups creates the busy lamp field (BLF) and

direct station select (DSS) settings on user phones. Refer to Display Status Group (Busy Lamp Field) on

page 38 to optionally select a status group to display on the phone. Note that this feature is only available

for the ADTRAN/Polycom SoundPoint IP 601.

1. Navigate to the

Voice > Applications > Status Groups menu.

2. Enter a name for the new status group and select Add New Status Group.

Figure 57. Status Group Menu Add/Edit/Delete Tab

3. From the Status Group Details Menu, add members to the status group by selecting Add User,

Add Park Zone, Add System Mode, or Add Mailbox. Choose members from the Status Group

Members

list using the check boxes. For users, specify whether to identify the user in the status

group by name or extension in the

Display Name column. This setting can be modified later on.

Figure 58. Status Group Details Menu

4. Select Apply to accept the new settings. An example of the phone display is shown in Figure 23 on

page 39.