Instruction manual

Section 4, User Interface Guide NetVanta 2000 Series System Manual
48 © 2002 ADTRAN, Inc. 61200361L1-1E
> ADMIN > REBOOT SYSTEM
The Reboot System page allows users to reboot the NetVanta 2000 series system from a remote location.
Click on
R
EBOOT
S
YSTEM
found in the option list on the left side of the display window to display the
Reboot System page.
Rebooting the NetVanta 2000 series system requires confirmation. Click
Y
ES
to proceed with the reboot
sequence or
N
O
to cancel. When you restart the system, the following actions take place:
1. The NetVanta 2000 series is unresponsive until the system reboot sequence is complete.
2. All network accesses currently active in the system will be terminated/interrupted until the system
reboot sequence is complete.
3. The NetVanta 2000 series reboot sequence is approximately 30 seconds in length. To resume
configuration of the NetVanta 2000 series successfully complete the login procedures.
4. After a system reboot, the NetVanta 2000 series resumes service using the last saved configuration.
To ensure a configuration change becomes permanent save the configuration once all changes are
complete. For saving configuration procedure details refer to > Admin > Save Settings on page 48.
> ADMIN > SAVE SETTINGS
During an NetVanta 2000 series web session all configuration changes are immediately implemented. The
updated configuration is not saved to flash memory until a manual configuration download is performed.
Until the configuration is saved to flash memory, it is not available across power failures and system
reboots. To save the current configuration of the NetVanta 2000 series, click on
S
AVE
S
ETTINGS
found in
the option list on the left side of the display window. Saving the NetVanta 2000 series system configuration
requires confirmation. Click
Y
ES
to proceed with the configuration download or N
O
to cancel. Once the
configuration download is complete a confirmation message is displayed. Refer to DLP-003, Saving the
Current Settings of the NetVanta for more details.
> ADMIN > FACTORY DEFAULTS
Restore the NetVanta 2000 series to default configuration by clicking on F
ACTORY
D
EFAULTS
found in the
menu list on the left side of the display window. Factory defaulting the NetVanta 2000 series requires
confirmation. Click
Y
ES
to proceed with the factory default process or N
O
to cancel. During the factory
default process, the NetVanta 2000 series erases the current configuration from memory and displays the
operation progress. When the configuration erase procedure is complete (estimated duration is a few
seconds) an operation completion message will be displayed and you will be instructed to reboot the
system manually to restore the factory default configuration. Refer to > Admin > Reboot System on page
48 for instructions on rebooting the NetVanta 2000 series system. Refer to DLP-021, Restoring the
NetVanta to Factory Defaults for more details.