Instruction manual

Section 4, User Interface Guide NetVanta 2000 Series System Manual
40 © 2002 ADTRAN, Inc. 61200361L1-1E
> CONFIG > NETWORK INTERFACE
The Network Interface configuration page is displayed by clicking on N
ETWORK
I
NTERFACE
found in the
option list on the left side of the display window.
> CONFIG > NETWORK INTERFACE > ETHERNET CONFIG > ETHERNET IP ADDRESS
The E
THERNET
IP A
DDRESS
section contains the information for both the Corporate (LAN) and WAN IP
addresses, and subnet masks.
The
C
ORPORATE
IP and S
UBNET
M
ASK
fields should be configured with parameters that correspond to the
corporate network connected to the LAN interface located on the back of the NetVanta 2000 series unit.
The
WAN IP T
YPE
should be set to D
YNAMIC
if your ISP is using DHCP to assign IP addresses dynamically
or
STATIC if your ISP has assigned you a specific IP address to use each time you connect. If your WAN IP
T
YPE
is S
TATIC
, the WAN IP and S
UBNET
M
ASKS
fields should be configured with the specific information
provided by your ISP.
The NetVanta 2000 series also supports PPPoE (PPP over Ethernet) to obtain a WAN interface IP address.
Select the
PPP
O
E radio button and enter the U
SERNAME
and P
ASSWORD
provided by your ISP in the
appropriate fields.
> CONFIG > NETWORK INTERFACE > RIP CONFIG > RIP CONFIGURATION
The R
IP
C
ONFIGURATION
field selects the RIP version being used by the NetVanta 2000 series. RIPONE is
standard Rip V1. The NetVanta 2000 series supports RIP V1 on both the LAN and WAN interfaces.
RIPTWO is standard RIP V2. NetVanta 2000 series supports RIP V2 on both the LAN and WAN
interfaces.
RIPCOMP is a combination of RIP V1 and RIP V2. When configured for RIPCOMP, the
NetVanta 2000 series is capable of listening to RIP V1 updates while maintaining full compatibility with
RIP V2 systems.
> CONFIG > NETWORK INTERFACE > RIP CONFIG > AUTHENTICATION TYPE
The Authentication Type field configures the NetVanta 2000 series to use the selected authentication when
performing RIP functions. If authentication is configured, other systems providing the NetVanta 2000
series with RIP updates must be configured for matching authentication. The NetVanta 2000 series
supports both
SIMPLEAUTH (using a single password) or MD5 authentication (requiring the use of keys
entered in the
MD5 AUTH KEY ID and MD5 AUTH KEY fields.
> CONFIG > NETWORK INTERFACE > DHCP INFO
The DHCP I
NFO
table for the NetVanta 2000 series displays the current DHCP client interface information
for both the LAN and WAN ports. This table is only valid if the NetVanta 2000 series is connected to a
network with an active DHCP server.
> CONFIG > ROUTES
The Routing table for the NetVanta 2000 series can be reached by clicking on R
OUTES
found in the menu
list on the left side of the display window. The following is a description of the routing table fields.