Instruction manual

Section 5, DLP-021 NetVanta 2000 Series System Manual
198 © 2002 ADTRAN, Inc. 61200361L1-1E
5. Click Yes to reboot the NetVanta 2000 series and restore all parameters to factory default settings.
6. Complete the steps in
DLP-001 to access the
NetVanta 2000 series
unit.
Perform Steps Below in the Order Listed - Hardware Default
1. Make sure the NetVanta 2000 series unit is powered up.
2. On the rear panel of the NetVanta 2000 series unit there is a factory default pinhole located between
the LAN and WAN interfaces. Push the factory default pinhole for 1-2 seconds to restore the LAN
interface factory settings.
Follow-up Procedures
Once this procedure is complete, return to the procedure which referred you to this DLP and continue with
the tasks indicated there.
Performing a factory default using hardware only restores the LAN interface
parameters to default state. The DHCP server will be enabled and the LAN interface
will be given an IP address of 10.10.10.1.