Instruction manual

61200361L1-1E © 2002 ADTRAN, Inc. 129
ADDING A DEFAULT ROUTE TO THE NETVANTA ROUTE TABLE
Introduction
The NetVanta 2000 series contains an internal router which allows multiple users to share a VPN
connection while the unit is still directing incoming IP traffic. The NetVanta 2000 series router supports
standard TCP/IP operation, static routes, and the use of RIP V1 and V2. This DLP discusses the procedure
for adding a default route to the NetVanta 2000 series route table.
Prerequisite Procedures
This DLP assumes the NetVanta 2000 series is connected to a PC and a browser session is active. Refer to
DLP-001 for more details.
Tools and Materials Required
• No special tools or materials required.
If you are using Static IP addressing on your WAN interface your Internet Service
Provider must provide you with the IP address of your first hop router. If you are using
DHCP (Dynamic) or PPPoE addressing, please complete the steps in DLP-022, Viewing
the DHCP Info Table before beginning this DLP. You will need to record the IP address
listed next to Gateways in the WAN interface column.
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.