Installation guide

Option Modules NetVanta 1000/1000R Series Hardware Installation Guide

NetVanta SHDSL NIM (P/N 1200867L1)

The NetVanta SHDSL NIM (shown in Figure 19) provides a WAN SHDSL interface for the NetVanta. See

Table A-10 on page 54 for the SHDSL connector pinouts. See Table A-13 on page 56 for the DBU

connector pinouts. An optional DIM is required for dial backup applications.

Figure 19. NetVanta SHDSL NIM

WAN-SHDSL

DBU

Features and Specifications

Operating Mode

• Line termination (CO)

• Network termination (CPE)

SHDSL Interface

• Supported Standards: ITU-T G.991.2

SHDSL

• Line Rate: 200 to 2312 kbps in

64k increments

• Line Code: TC-PAM

• Connector: RJ-45

Clock Source

• CPE Operating Mode: Network

• CO Operating Mode: Internal

Diagnostics

• Test Pattern Generation and Detection:

- 1

• Network loopbacks (local and remote)

• Alarm generation and detection

• Programmable alarm threshold setting for

loop attenuation and signal-to-noise ratio

Compliance

• EMC - see Electromagnetic

Compatibility (EMC) Table for the

NetVanta 1224STR/1224R on page 6.

•AS/ACIF S043

• EN 60950

• AS/NZS 60950

Environmental

• Operating Temperature: 0°C to 50°C

• Storage Temperature: -20°C to 70°C

• Relative Humidity: Up to 95 percent,

noncondensing

Physical

• Dimensions: 2.75-inch W x 4.25-inch D