Installation guide

NetVanta 1000/1000R Series Hardware Installation Guide Physical Description

3. PHYSICAL DESCRIPTION

Front Panel RJ-45 Ports and LEDs

The NetVanta 1224, NetVanta 1224ST, NetVanta 1224STR, NetVanta 1224STR PWR, and

NetVanta 1224R front panels contain twenty-four 10/100BaseT Ethernet ports (RJ-45). The NetVanta

1524ST front panel contains twenty-four 10/100/1000BaseT Ethernet ports. These ports are consecutively

numbered one through twenty-four, from left to right, with the numbers screened directly above each port.

Status LEDs for each of these ports are located directly over these numbers. (See Figures 1 through 8.)

Front Panel Gigabit Ethernet Interfaces and LEDs

In addition to the Ethernet ports, the NetVanta 1224ST and 1224STR PWR front panels contain two

Gigabit Ethernet interfaces, and the NetVanta 1224STR contains one Gigabit Ethernet interface. These

interfaces are provided as SFP slots and RJ-45 jacks. Use either the SFP slots (refer to SFP Module Slots

on page 22) or the RJ-45 jacks. These interfaces are labeled

G1 and G2, and their status LEDs (also labeled

G1 and G2) are located to the left of RJ-45 port 1, above the STAT LED on the NetVanta 1224ST and

1224STR. On the NetVanta 1224STR PWR, the

G1 and G2 status LEDs are located on the right side of the

unit above the SFP slots. The NetVanta 1224R PWR, 1224ST PWR, and 1224STR PWR also have red and

green Power over Ethernet status LEDs located in the upper right and upper left corners (respectively) of

each of the Ethernet and Gigabit Ethernet (where applicable) connectors.

Other Front Panel LEDs

The STAT LED, which indicates the unit’s status, is located to the lower left of RJ-45 port 1. The

NetVanta 1224STR and NetVanta 1224R also contain LEDs labeled

WAN and DBU. The WAN LED

reflects the status of an installed NIM, and the

DBU LED reflects the status of an installed DIM. The

NetVanta 1524ST has the

STK LED, which indicates whether the 1524 is a member of a stack. Table 1 on

page 23 describes all of these LEDs, and Appendix A shows the pinouts for the connectors.

Figure 1. NetVanta 1224 Front Panel Layout

Figure 2. NetVanta 1224ST Front Panel Layout

Figure 3. NetVanta 1224STR (AC and DC Versions) Front Panel Layout