Specifications

Section 3, Application Guidelines - MX3RMM Data Path Block Diagram
61189008L1-1B 3-11
MX3216 with Remote Management Application
The MX3RMM provides the capability to remotely manage the MX3216 system. The MX3RMM
bridges Ethernet traffic between two Point-to-Point Protocol (PPP) over T1/FT1 (Fractional T1)
interfaces, a front panel Ethernet jack, and the rear chassis Ethernet jack. The Ethernet
traffic is encapsulated in PPP for transport over the T1/FT1. In addition to remote
management, this also provides LAN access through both Ethernet jacks giving the ability to
remotely manage other systems located on the same network. Figure 3-10 illustrates this
application.
Figure 3-10. MX3216 with Remote Management Application Diagram
Table 3-3 shows the equipment needed for an MX3216 with remote management application.
Table 3-3. MX3216 with Remote Management - Required Equipment
Part # Equipment Quantity
1189001L1 MX3 Chassis 1
1189004L1 MX3 Remote Management
Module (MX3RMM)
1
1189007L1 MX3 Fan Module 1
1189008L1 MX3216 Controller Card 1 (2 for redundancy)
ENET
MX3216
Drop DS1s
ENET
RMM
ENET
MX3216
DS3
Drop DS1s
28 DS1s
from
Central Site
Central Site Remote Site #1 Remote Site #2
DS3
µ Wave/
Leased
DS3
DS3DS3
DS3
µ Wave/
Leased
DS3
ENET
RMM
DS3
Technician
Manages all
MX3216 units from
any Cell Site and
accesses IP Network
(e-mail, etc.)