Specifications

Section 6, User Interface - Menu Descriptions
61189008L1-1B 6-113
Ethernet Interface Menu
The Ethernet Interface menu (see Figure 6-71) is used to set the Ethernet state, link speed
and duplex, and cross-over mode for the Ethernet connection on the MX3RMM.
NOTE
The MX3RMM bridges traffic to the rear panel Ethernet jack on the
MX3 chassis. To configure that interface, refer to the
“Rear Ether-
net Interface Menu” on page 6-44.
Figure 6-71. Ethernet Interface Menu
The Ethernet Interface menu options are shown in Table 6-79.
Card: Module A ADTRAN MX3216 System MM/DD/YY hh:mm
Unacknowledged Alarms: NONE ID: Site 1 MX3216
Ethernet
1 - Ethernet State : Enabled
2 - Link Speed & Duplex : Auto
Functional Link Speed & Duplex : Unknown
3 - Cross-over Mode : Auto
Link Status : Down
Selection : '?' - System Help Screen