User manual

ADTRAN IP 700 Series Phone User Manual Connecting to the Power Source

3. CONNECTING TO THE POWER SOURCE

Once the IP 706 and IP 712 phones have been assembled, it is necessary to connect the phones to a power

source and the phone system. There are two options available to supply power to your IP phone. Use the

Local Power Option if your wall jack is not Power over Ethernet (PoE) enabled. This option requires using

the optional PoE power supply (P/N 1200809E1 or P/N 1200809E#IN). If your wall jack is PoE enabled,

use the Inline Power Option which does not require the optional PoE power supply. Use the following

steps to complete these tasks.

Local Power Option

1. Connect one end of the included Ethernet cable to the Ethernet jack on the back of the phone.

2. Connect the remaining end to the

J1 DATA AND POWER port on an appropriate PoE-enabled

device.

3. Connect one end of a second Ethernet cable (not included) to the

J2 DATA port on the PoE device.

4. Connect the remaining end of the second Ethernet cable (not included) to the non-PoE wall jack.

5. Connect the PoE power supply to the wall outlet.

Figure 4. Connecting to the Local Power Source

Use the Local Power Option if your jack is NOT PoE enabled. If your jack is PoE

enabled, a PoE power supply is not necessary.

Network connectivity is provided through the wall jack, allowing an optional PC

connection through the IP phone. If the IP phone is disconnected from either the network

or power source, network connectivity from the phone to the attached PC will be lost.

POWER

DATA & PWR

Optional

PoE Power Supply

Non-PoE Wall

Jack

Optional PC

Connection