Instruction manual

Appendix A. Configuration and Line Parameters ADTRAN IP 700 Series Phone Administrator Guide
68 Copyright © 2011 ADTRAN, Inc. 6AOSAG0001-31A
IdleSelectOrder 0 to 4 Defines the idle and originate preference
selection order:
0=Select previous active and connected
1=Select lowest available index
2=Select highest available index
3=Select circular form, previous active and
connected
4=No Select (incoming calls presented on
highest available)
Default: 1
Config File
Web Interface
Include Up to 64
ASCII
Characters
Specifies a file name that is included in the
master configuration file. Files may be
specified completely, or may include the
variable $Hardware. The value of the
Hardware Version (programmed into flash
at the factory, e.g., K01M01P01L01) is
substituted for $Hardware when the file
name is created. This will permit
parameters to be specified based on a
specific hardware release.
Config File
IPAddress N/A Specifies the IP address for the phone.
Default: 0.0.0.0
DHCP
Phone Interface
Web Interface
Layer2Audio 0 to 7 Specifies outbound tagging on audio
packets.
Default: 5
Config File
Layer2Signaling 0 to 7 Specifies outbound tagging on signaling
packets.
Default: 3
Config File
Web Interface
Layer2Tagging True or
False
Enables (true) or disables (false) VLAN
tagging.
Default: False
DHCP
Phone Interface
Web Interface
LineSeizeFaliure True or
False
Enables tone notification when attempts to
seize an SCA line fails (e.g., another user
seizes the call first).
Default: True
Config File
Web Interface
Table 12. Configuration Parameters (Continued)
Parameter Value Type Description Sources