Instruction manual

Connecting the Power Source ADTRAN IP 700 Series Phone Administrator Guide

Inline Power Option

1. Connect one end of the included Ethernet cable to the Ethernet jack on the back of the phone.

2. Connect the remaining end of the Ethernet cable to the PoE wall jack.

Figure 5. Connecting to the Inline Power Source

Power Specifications

The IP 706 and IP 712 phones support the following powering specifications:

• IEEE 802.3af powering on signal or spare pairs independent of polarity

• Presents a valid IEEE 802.3af detection signature on both the signal and spare pairs

• Presents a Class 2 signature when a valid signature is required

• Draws less than 6.49 W of power under normal operating conditions

Network connectivity is provided through the PoE wall jack, allowing an optional

PC connection through the IP phone.

All powering over telecommunication wiring must be via UL-listed power supplies with

outputs of 48 VDC  1 percent, 350 mA maximum.

Optional PC

Connection

PoE Wall

Jack