Instruction manual

Chapter 2. Installation
2-4 Express 3010/3110 User Manual 61200239L1-20
Windows NT 3.51 Users
1. Locate the
modem.inf
file. This file is normally located in the
c:\winnt35\system32\ras
directory. See the Windows NT
documentation for instructions on installing the Remote Access
Service.
2. To recover your files in case of a user mistake, create a backup of
the modem.inf file.
3. Using Notepad, open the
adtran.inf
file (on the Express CD).
4. Copy the contents of the
adtran.inf
file into the Windows clip-
board.
5. Open the modem.inf file.
6. Paste the contents of the clipboard (
adtran.inf
) to the end of the
modem.inf
file.
7. Save the new altered
modem.inf
and close the file.
8. Restart the system.
MACINTOSH INSTALLATION INSTRUCTIONS
Hardware Installation
1. With the Macintosh’s power off, connect the
EIA232
serial port
on the Express to an available communications port on the
Macintosh.
Be sure to use a Macintosh high-speed modem cable. Macintosh
high-speed modem cables are available at any electronics store that
carries Macintosh equipment.
2. Plug the Express’s AC power cord into the port labeled
PWR
.
Plug the other end into a 120 V electrical outlet. The Express is
now powered on.
3. Plug the RJ-45 connector (large end) of the RJ-45-to-RJ-11 tele-
phone cable into the jack labeled
ISDN
on the rear of the Express.
4. Plug the RJ-11 connector (small end) of the RJ-45 to the RJ-11 tele-
phone cable into the ISDN telephone wall jack.
5. Power on the Macintosh.