Specifications

Chapter 2. Setting Up the Express 3000 SP
2-2 Express 3000 SP User Manual 61203153L3-20
WINDOWS INSTALLATION PROCEDURE
The following Step/Action tables provide step-by-step instructions
for installing the Express 3000 SP. However, the basic installation pro-
cedure is as follows:
1. Connect and power up the hardware (see page 2-2).
2. Install the Express 3000 SP into the operating system (see page 2-
3).
3. Install the Express Configuration software (see page 2-4).
Connecting the Hardware: Windows
As the first step in getting your Express 3000 SP up and running, in-
stall the hardware. To ensure success, closely follow the instructions
below—particularly those relating to installing the cables.
Windows Instructions for Connecting the Hardware
Step Action
1 Connect the Express 3000 SP to the PC:
With the computer’s power off and using an appropriate serial
cable (this serial cable is not provided—see Table 1-1 on
page 1-3), connect the EIA-232 port on the Express 3000 SP
to an available COM port on the computer.
2 Power on the Express 3000 SP:
Plug the Express 3000 SP power supply cord into the port on
the unit labeled
PWR
. Plug the other end into an electrical
outlet. The Express 3000 SP is now powered on.
3 Connect the Express 3000 SP to the ISDN line:
Plug one end of an RJ-11 cable into the jack on the rear of the
Express 3000 SP labeled
ISDN
; plug the other end of the
cable into the ISDN telephone wall jack.
4 Power on the computer.
5 Insert the provided Express 3000 SP CD-ROM into the
CD-ROM drive.