Specifications

Configuring Global Radio Settings
BlueSecure™ Controller Setup and Administration Guide 12-15
Load Balancing Enter the Average user count per AP, which is the average number of wireless devices that
may associate any BSAP before the BSC balances the client load among the BSAPs. Valid
values for this setting are:
• BSAP-1500 and BSAP-1540: 1-56
• Other AP models: 1-64
Enforcement: Select the relative strength of each BSAPs’ enforcement of the specified
average AP client count
• Low: BSAP rejects a client device once before allowing it to associate.
• Medium: BSAP rejects a client device up to three times before allowing it to
associate.
• High: BSAP rejects a client device up to five times before allowing it to associate.
• Always Reject: Hard cap the number of users on an individual AP.
QoS Settings Optional. Enable system-level QoS on the BSAP for voice and video traffic. (See
“Configuring VoWLAN QoS” on page 9-3 for background information on VoIP.):
1. To enable WMM settings, mark the Enable WMM and Voice Call Admission
Control? checkbox.
2. Mark the Enable SVP checkbox to enable Polycom/Avaya Voice Protocol(SVP).
Admission
Control Settings
If WMM is enabled you can specify the following:
1. Enter the maximum number of voice clients that may associate to the BSAP in the
Voice Sessions field.
2. Enter the maximum number of video clients that may associate to the BSAP in the
Video Sessions field.
The above maximum voice and video sessions settings affect only SSIDs that have voice
and video QoS enabled. See “Creating SSIDs” on page 12-20 for information about
creating/editing BSAP SSIDs. Note that a BSAP’s system-level QoS and the Wi-Fi
multimedia QoS that you enable for voice and video SSIDs are complementary. We
recommend that you enable both QoS methods when passing voice or video traffic on
the BSAP.
BSAP-1700 and
BSAP-1800
MIMO Settings
For BSAP-1700s and BSAP-1800s (MIMO), specify the following:
1. BSAP1700: MIMO Compression Mode: (Requires a special client adapter)
Data frames are compressed by hardware, which can increase data throughput. A
special MIMO client is required for this feature.
• 0 = Disabled
11N 6.5Mbps
13Mbps
19.5Mbps
26Mbps
39Mbps
52Mbps
58.5Mbps
65Mbps
6.5Mbps
13Mbps
19.5Mbps
26Mbps
39Mbps
52Mbps
58.5Mbps
65Mbps
78Mbps
104Mbps
117Mbps
130Mbps
13.5Mbps
27Mbps
40.5Mbps
54Mbps
81Mbps
108Mbps
121.5Mbps
135Mbps
150Mbps
13.5Mbps
27Mbps
40.5Mbps
54Mbps
81Mbps
108Mbps
121.5Mbps
135Mbps
150Mbps
162Mbps
216Mbps
243Mbps
270Mbps
300Mbps