User manual

Appendix A. Dial Plan Interface Configuration
61200773L1-1A ATLAS 800 Series Video Module User Manual 41
The following menus are only available when the D
IALING
M
ETHOD
is M
ANUAL
.
R
EDIAL
N
UMBER
Write Security: 3; Read Security: 5
Activator to dial or disconnect a call to the specified number.
D
IAL
N
UMBER
Write Security: 3; Read Security: 5
Specifies the number to dial on an outgoing call.
C
ALL
T
YPE
Write Security: 3; Read Security: 5
Specifies whether the data rate on the call will be 56 or 64kbps.
D
IAL
C
ALL
A
S
Write Security: 3; Read Security: 5
Specifies the call type used to populate the Bearer Capability Information Element
in the ISDN Call Setup Message. Options include: D
IGITAL
(Data), V
OICE
(speech),
or AUDIO
(3.1 kHz audio).
S
OURCE
ID
Write Security: 3; Read Security: 5
Defines the source ID assigned to this call to be used for internal ATLAS routing.
Source IDs simplify the creation of a dial plan in applications where the criterion
for switching calls to a certain endpoint is a function of which endpoint originated
the call.
M
IN
DS0
S
Write Security: 3; Read Security: 5
This option will specify the minimum number of DS0s necessary for this switched
call. If the call is negotiated and the minimum DS0s value is not met, the call will
be disconnected. Any value other than 1 requires a BONDING resource to inverse
multiplex the multiple switched channels together.
M
AX
DS0
S
Write Security: 3; Read Security: 5
This option will specify the maximum number of DS0s allowed for this switched
call. If the call is negotiated and the maximum DS0s value is not acceptable to the
answering equipment, the call will be disconnected. Any value other than 1 requires
a BONDING resource to inverse multiplex the multiple switched channels
together.
S
TORED
N
UMBERS
Write Security: 3; Read Security: 5
Enter the numbers to dial using the RS-366 Type II dialing interface in the stored
numbers list. This list can contain up to 10 stored numbers.
#
Entry number (1-10).