Troubleshooting guide

Configuration Command Summary

Step 8 (config-bgp)#neighbor <ipv4 address> Enters BGP Neighbor Configuration

mode for the neighbor to which the route

map is to be applied.

Step 9 (config-bgp-neighbor)#send-community

standard

Enables this AOS device to accept a

community attribute or adds a

community attribute to any

advertisement sent by this peer.

Step 10 (config-bgp-neighbor)#route-map <name> in Applies the route map to the BGP

neighbor as an inbound policy.

Step 11 (config-bgp-neighbor)#do write Saves the configuration.

Refer to BGP Communities on page 13 for additional configuration options and more

detailed information on the BGP community commands listed in Table on page 62.

Table 8. Defining a Community Policy (Continued)

Command Description