Troubleshooting guide

Basic BGP Configuration Using the CLI

The following example configures a remote AS number of 200 for neighbor 172.16.1.2:

(config)#router bgp 1

(config-bgp)#router bgp-neighbor 172.16.1.2

(config-bgp-neighbor)#remote-as 200

Assuming the neighbor is properly configured, the AOS device should now be able to connect to the

neighbor and exchange routes with it.

Step 4: Save the Configuration

The configuration can be saved directly from the BGP Configuration mode or BGP Neighbor

Configuration mode:

(config-bgp-neighbor)#do write

When configuring eBGP, the remote AS number must be different from that of the local

router (which is defined using the router bgp command).

When the command to save the configuration is issued from the Enable mode, the command

is: write.