Installation guide

Unit Installation NetVanta 6355 PoE Hardware Installation Guide

Figure 14. Wallmount Installation

Supplying Power to the Unit

The NetVanta 6355 PoE unit comes equipped with an auto-sensing 100 to 250 VAC, 50/60 Hz power supply for

connecting to a properly grounded power receptacle. (A detachable power cable with a grounded, three-prong

plug comes with the shipment.) To power this unit, connect the power cable to an appropriate AC power source.

Installing Network and Voice Interface Modules

NIMs/VIMs are installed into the rear panel option module slot. The following tables list the installation steps.

Also see Figure 15 on page 37.

For NetVanta modules with outside plant connections, ensure that all cables are

removed from the module before installing or removing it from the NetVanta chassis.

Always remove power from the unit and all telecommunication connections prior to

removing or installing a module.

Improper installation may result in damage to the modules.