Manualshelf

Installation guide

ManualsBrandsADTRAN ManualsComputer equipment6355PoE
31323334353637383940
NetVanta 6355 PoE Hardware Installation Guide Unit Installation
61200740E1-34D Copyright © 2011 ADTRAN, Inc. 33
4. UNIT INSTALLATION
The instructions and guidelines provided in this section cover hardware installation topics, such as mounting
options, supplying power to the unit, and installing option cards. These instructions are presented as follows:
• Mounting Options on page 34
• Supplying Power to the Unit on page 36
• Installing Network and Voice Interface Modules on page 36
• Installing the NetVanta VPN Accelerator Card (included in P/N 4200368L1) on page 38
• Installing a CompactFlash Card on page 39
For information on configuration for a specific application, refer to the configuration guides provided online on
the ADTRAN’s Knowledge Base at http://kb.adtran.com
.
Tools Required
The customer-provided tools required for the hardware installation of the NetVanta are:
• Ethernet cables
• Network cables (module dependent)
• DSX-1 cable (T1/FT1 + DSX-1 module only)
• Phillips-head screwdriver (rack-mounted applications only)
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
Electronic modules can be damaged by static electrical discharge. Before handling
modules, put on an antistatic discharge wrist strap to prevent damage to electrical
components. Place modules in antistatic packing material when transporting or storing.
When working on modules, always place them on an approved antistatic mat that is
electrically grounded.
The NetVanta 6355 PoE is intended to be installed, maintained, and serviced by qualified
service personnel only and should be installed in a restricted access location as described
in UL/IEC 60950-1.
Ethernet and PoE cables are intended for intra building use only. They should not be run
outside the building.
To access the CLI of the NetVanta, you will also need a PC with terminal emulation
software and a console port cable. Instructions on how to access the CLI are available in
the quick start guide shipped with your unit or online at ADTRAN’s Knowledge Base
.