Installation guide

Physical Description NetVanta 6355 PoE Hardware Installation Guide

NetVanta 6355 PoE Front Panel Design

The NetVanta 6355 PoE front panel is shown in Figure 1 on page 18. Table 1 on page 19 describes all of the

LEDs, and Appendix A on page 41 shows the pinouts for the connectors.

NetVanta 6355 PoE Front Panel Features

10/100Base-T Ethernet Interfaces

The NetVanta 6355 PoE front panel contains 24 10/100Base-T Ethernet interfaces (RJ-45). These

interfaces are consecutively numbered 1 through 24, from left to right, with the numbers screened

directly above each port. Status LEDs for each of these interfaces are located directly over these

numbers.

The NetVanta 6355 PoE also has green and red PoE status LEDs located in the upper-left and

upper-right corners (respectively) of each Ethernet connector.

Gigabit Ethernet Interfaces/SFP Slots

The NetVanta 6355 PoE front panel contains two Gigabit Ethernet interfaces that provide two fixed

RJ-45 connectors and two standard SFP slots for connectivity over fiber. (Use either the RJ-45

connectors or the SFP slots. The fiber slots have precedence.) These interfaces are labeled

G1 and G2,

and the status LEDs are located above the SFP slots.

Status LEDs

The status LEDs are located to the lower left of RJ-45 port 1. The SLOT 1 LED reflects the status of a

NIM/VIM installed in NIM/VIM option

SLOT 1 (located on the rear panel). The SLOT 2 LED reflects

the status of a NIM/VIM installed in NIM/VIM option

SLOT 2 (located on the rear panel). The STAT

LED indicates the unit’s status.

Figure 1. NetVanta 6355 PoE Front Panel Layout

NetVanta 6355